热解酸洗污泥用于氮氧化物还原的研究

金属表面处理过程排出的酸洗废水经处理产生的酸洗污泥,若是处理不合理就会引发极其严重的环境污染问题,经过热解处理后可以得到含有碳和重金属的固体产物.以热解酸洗污泥为还原剂,考察其脱硝性能以及反应温度、氧气浓度、反应时间对热解酸洗污泥脱硝效率的影响.结果 表明,该热解酸洗污泥有良好的脱硝性能,在反应温度为800℃,氧气浓度为1％的条件下,脱硝效率可达95.093％,可以作为脱除NOx的还原剂.热解酸洗污泥的脱硝效率随着温度的升高和氧气浓度的增加而降低,并且随着时间的推移,脱硝效率下降较快.     

电磁精细探测法在隐伏型导水地质裂缝勘探中的应用

针对传统隐伏型导水地质裂缝勘探方法存在勘测精度较差的问题,提出电磁精细探测法探析隐伏型导水地质裂缝。依照屏蔽系数、实测场强和理论场强数据绘制综合曲线图,通过该图获取隐伏型导水地质裂缝所处位置几何阴影范围,采用层析成像法得到网格化的工作面,获取隐伏型导水地质图像。通过图像直接观测隐伏型导水地质工作面裂缝所处位置,在此基础上,观测四个电磁场分量,采用正交电磁场分量计算介质视电阻率,依据计算视电阻率数值和视电阻率分布状态研究裂缝发育情况和裂缝富水程度。结果表明:采用该方法能较为精准地获取隐伏型导水地质裂缝位置。通过裂缝位置进一步检测出隐伏型导水地质裂缝最大发育高度为63.5 m。当视电阻数值不断增加时,隐伏型导水地质裂缝和裂缝富水性逐渐减小,与实际情况较为相符,说明该种方法探析效果较好。     

电视民生新闻现状及发展趋势探析

自2002年起,我国开始出现电视民生新闻,并得到观众的广泛喜爱,但在整个发展过程当中电视新闻存在一些问题有待解决,探讨电视民生新闻的现状及发展趋势,对其中存在的问题提出解决方案。     

分子筛脱水吸附塔的结构应力与疲劳分析

综合考虑分子筛脱水吸附塔的结构、疲劳状况及管口载荷等因素,利用ANSYS对吸附塔进行结构应力与疲劳分析。计算结果表明:所建立的吸附塔整体模型合理;该结构在确保可靠性的基础上可降低制造成本;该设备能满足疲劳寿命的要求。     

固相反应快速制备铜掺杂方钴矿及其热电性质研究

采用固相反应法在制备温度923 K,保温时间约30 min的条件下,快速合成了铜掺杂方钴矿Cux Co4 Sb12(x=0、0.1、0.3、0.5、0.7、0.9),对样品进行了物相结构(XRD)、微观结构和不同温度条件下的热电性质测试分析.结果表明,所制备的样品Cux Co4 Sb12在0≤x≤0.7的范围内均为单相的方钴矿结构,样品含有许多微气孔,晶粒细小,平均直径在微纳米级.当测试温度为696 K时,样品Cu0.1 Co4 Sb12获得最低电阻率为48.71μΩ·m.在测试温度为462 K时,样品Cu0.3 Co4 Sb12获得最大Seebeck系数为233.14μV/K.样品Cu0.1 Co4 Sb12在测试温度为578 K时,获得最大的ZT值为0.24.     

Research on the identification performance of UHF RFID system considering the correlation of cascaded channel

The identification rate of UHF RFID system was restricted by multipath propagation effects.The system identification performance was studied considering the correlation coefficient between forward and reverse channels.Based on the generalized Rician fading channel model,the analytical expression of identification rate was derived under independent,full correlation and correlation cases.Compared with the existing analysis,the proposed uniform calculation formula of identification rate was for any correlation coefficient and kinds of channel conditions.The numerical computation and Monte-carlo simulations show that the influences of different correlation coefficients,channel conditions,sensitivity and distance on the identification rate.     

Phase stability and thermo-physical properties of ZrO2-CeO2-TiO2 ceramics for thermal barrier coatings

The properties of ZrO₂ co-stabilized by CeO₂ and TiO₂ ceramic bulks were investigated for potential thermal barrier coating (TBC) applications. Results showed that the (Ce_0.15Ti_x)Zr_0.85-xO7 (x?=?0.05, 0.10, 0.15) compositions with single tetragonal phase were more stable than the traditional 8YSZ at 1573?K. These compositions also showed a large thermal expansion coefficient (TEC) and a high fracture toughness, which were comparable to those of YSZ. However, the phase stability, fracture toughness and sintering resistance of the CeO₂-TiO₂-ZrO₂ system showed a decline tendency with the increase of TiO₂ content. The TEC of the ceramic bulks decreased with increase of TiO₂ content as well because the crystal energy was enhanced with increasing substitution of Zr⁴⁺ by smaller Ti⁴⁺. The (Ce_0.15Ti_0.05)Zr_0.8O₂ had the best comprehensive properties among the (Ce_0.15Ti_x)Zr_0.85-xO₂ compositions as well as a low thermal conductivity. Therefore, it can be explored as a TBC candidate material for high-temperature applications.     

Polyurethane/doxorubicin nanoparticles based on electrostatic interactions as pH‐sensitive drug delivery carriers

In order to obtain a pH‐sensitive delivery carrier for doxorubicin (DOX), DOX‐loaded polyurethane (PU·DOX) nanoparticles were readily prepared in water by electrostatic interactions between amphiphilic polyurethane with carboxyl pendent groups (PU‐COOH) and doxorubicin hydrochloride (DOX·HCl). The structures of the products obtained were characterized by Fourier transform infrared spectroscopy, ¹H NMR spectroscopy, gel permeation chromatography, UV–visible spectroscopy, dynamic light scattering and transmission electron microscopy. The average hydrodynamic size of the PU·DOX nanoparticles was around 182 nm with negative surface charge (?1.1 mV) and a spherical or rodlike shape. PU·DOX nanoparticles had a higher drug‐loading content of 14.1 wt%. The in vitro drug release properties of PU·DOX nanoparticles were investigated at pH 4.0, 5.0 and 7.4, respectively. PU·DOX nanoparticles exhibited a good pH‐sensitive drug release property, but there was almost no release of DOX from PU·DOX nanoparticles at pH 7.4. The in vitro cellular uptake assay and the Cell Counting Kit‐8 assay demonstrated that PU·DOX nanoparticles had a higher level of cellular internalization and higher inhibitory effects on the proliferation of human breast cancer (MCF‐7) cells than pure DOX. The enhancement of the inhibition effects resulted from increasing apoptosis‐inducing effects on MCF‐7 cells, which was related to the enhancement of Bax expression and the reduction of Bcl‐2 expression confirmed by terminal deoxynucleotidyl transferase mediated dUTP nick end labeling (TUNEL) assay, real‐time polymerase chain reaction (PCR) assay and western blot assay. © 2018 Society of Chemical Industry